| Details |
Logboat, discovered in 1820 during marl-digging in the partly-drained Loch of Kinnordy, close to the already revealed crannog (NO35SE0007). The boat lay horizontally in the upper layer of marl, immediately below the peat layer. Hutcheson adds that it was found at a depth of about 3m and that a 'thunderbolt axe' (probably a polished stone axe) was found in it but subsequently lost. Cervid bones were also found in the layer. The boat was recorded by (Sir) Charles Lyell, the eminent geologist, and was found to be of 'oak' it measured 4.6m in length 'from bow to stern' and its 'width within' was 0.9m. No evidence of propulsion was seen but within the stern there was a 'seat for the boatman' while the prow 'had evidently been carved into an ornamental shape, representing, apparently, the head of some animal'. The boat was analysed in its geological context and assumed to be of prehistoric date, as Lyell noted that 'it shows, that some part even of the peat, which overlies all the marl, is of a date anterior to the historical records of the county'. The boat has, however, since been radiocarbon-dated to 735 +/- 40 ad, (Q-3142) which determination may be calibrated to about 791 or 801 cal AD. The boat was kept for some years in Kinnordy House but is now in store at Dundee Museum and Art Gallery . Mowat describes the boat as follows : 'It has suffered considerable splitting and gross deformation through warping so that the bow has been twisted through about 45 degrees to port, causing a much-distorted plan view to be presented. The large gash in the forward section of the starboard side was possibly caused during recovery operations. The workmanship displayed in the boat is of an unusually high order, there being little differentiation internally between the sides and the bottom, which only measure between 20mm and 40mm in thickness in spite of thickness-gauges not having been used. The timber is generally smooth and relatively free of knots, and there are slight traces of possible toolmarks internally amidships and near the stern. The exterior displays a slight chamfer in the lower part of the sides. After shrinkage, the boat measures 4.32m in length over all and up to about 0.85m in beam. It has probably been parallel-sided on plan although the variation in the heights of the side presents a misleading impression in plan view. The sides themselves survive to a height of about 0.35 amidships but rise to about 0.65m at the pointed bow, where the possible animal head that Lyell noted is probably to be explained as fortuitous, although the hole may have served to retain a boat-rope. The stern is solid and square-cut internally but is externally sub-rectangular. The fitted seat has been lost and no support for it can now be distinguished. Making allowance for distortion in shrinkage, the slenderness coefficient of this boat was 4.3, the beam/draught coefficient was 1.3 and the displacement under standard conditions was about 1.43 cubic metres, indicating that this was a small and general-purpose craft. The McGrail morphology code for this boat is 532:1x2:352 and the form is dissimilar-ended.'
|
Historic Environment Records (HER) 
Angus
HER -
NO35SE0012 - LOCH OF KINNORDY